Smart Battery Isolator 12V 100A

Smart Battery Isolator 12V 100A from BATTEK Battery Management System

By: BATTEK Battery Management System  10/02/2014
Keywords: Smart Battery Isolator

The Smart Battery Isolator is designed for use in Dual Battery applications as a solenoid priority system to protect the chassis charging system from excessive loading while allowing auxiliary batteries to be charged. The Smart Battery Isolator sense the input voltage generated and automatically connect/disconnect the appliance or circuit at pre-set voltages, eliminating the possibility of discharging the primary starting battery. Solenoid Based Smart Battery Isolator is much better in handling large surge current application (example like motor, wrench etc) than traditional relay based VSR. This unit allow a intermittent current of 200A and continuous current of 100A. Smart Battery Isolator is ideal for dual battery set-ups as they enable two batteries to be charged at the same time and then isolates the batteries from each other when the vehicle is turned off, ensuring your starting battery is always charged & ready to go. Free Shipping to USA, Canada, UK, Australia, New Zealand and rest of the Europe, Japan and Asia! Features: - Designed for dual battery systems - Suitable for most 12V charging systems - Surge Protection - Easy to install - Automatically sensing voltage level of main battery - Cut In Voltage: 13.4V - Cut Out Voltage: 12.8V - Turn On Delay: 5 sec (max.) - CE Certified

Keywords: Smart Battery Isolator

Contact BATTEK Battery Management System

Email

Print this page

Other products and services from BATTEK Battery Management System

Voltage Sensitive Relay 12V 140A Dual Sense from BATTEK Battery Management System thumbnail
03/04/2015

Voltage Sensitive Relay 12V 140A Dual Sense

The Voltage Sensitive Relay (VSR) connect or disconnect dual batteries based on the battery condition. When the engine is started and the start battery reaches 13.3 volts, the VSR engages to allow two battery banks (start and auxiliary) to be charged at the same time.


Low Voltage Disconnect 12V 30A from BATTEK Battery Management System thumbnail
10/02/2014

Low Voltage Disconnect 12V 30A

The ideal solution for protecting expensive deep cycle batteries from over-discharge. Automatically disconnects the load when the LVD detects the voltage has dropped to the disconnection point, ideal for 4WDs, camper trailers and smaller caravan applications. - Prevents damaging the battery through over discharge - Set the disconnect voltage to best suit the application - Multi-colour L.E.D indicates connection status of LVD - Potted electronics prevent dust and water ingress


Voltage Sensitive Relay 12V 140A from BATTEK Battery Management System thumbnail
10/02/2014

Voltage Sensitive Relay 12V 140A

Voltage Sensitive Relays have been specifically designed for a wide variety of 12V applications. The VSR units sense the input voltage generated and automatically connect/disconnect the appliance or circuit at pre-set voltages, eliminating the possibility of discharging the primary starting battery.