Voltage Sensitive Relay 12V 140A Dual Sense

Voltage Sensitive Relay 12V 140A Dual Sense from BATTEK Battery Management System

By: BATTEK Battery Management System  03/04/2015
Keywords: rv, Caravan, 4wd

The Voltage Sensitive Relay (VSR) connect or disconnect dual batteries based on the battery condition. When the engine is started and the start battery reaches 13.3 volts, the VSR engages to allow two battery banks (start and auxiliary) to be charged at the same time. When the voltage drops below 12.8 volts (such as the case in which the engine is stopped), the VSR disengages, separating the batteries. This system eliminates the possibility of draining the start battery and protects sensitive electronic equipment powered from the auxiliary battery from harmful engine start up spikes.

Keywords: 12V voltage sensitive relay, 4wd, Caravan, Dual Battery System, rv, Voltage Sensitive Relay, voltage sensitive relay ebay, voltage sensitive relays,

Contact BATTEK Battery Management System

Email

Print this page

Other products and services from BATTEK Battery Management System

Low Voltage Disconnect 12V 30A from BATTEK Battery Management System thumbnail
10/02/2014

Low Voltage Disconnect 12V 30A

The ideal solution for protecting expensive deep cycle batteries from over-discharge. Automatically disconnects the load when the LVD detects the voltage has dropped to the disconnection point, ideal for 4WDs, camper trailers and smaller caravan applications. - Prevents damaging the battery through over discharge - Set the disconnect voltage to best suit the application - Multi-colour L.E.D indicates connection status of LVD - Potted electronics prevent dust and water ingress


Smart Battery Isolator 12V 100A from BATTEK Battery Management System thumbnail
10/02/2014

Smart Battery Isolator 12V 100A

The Smart Battery Isolator is designed for use in Dual Battery applications as a solenoid priority system to protect the chassis charging system from excessive loading while allowing auxiliary batteries to be charged. The Smart Battery Isolator sense the input voltage generated and automatically connect/disconnect the appliance or circuit at pre-set voltages, eliminating the possibility of discharging the primary starting battery.


Voltage Sensitive Relay 12V 140A from BATTEK Battery Management System thumbnail
10/02/2014

Voltage Sensitive Relay 12V 140A

Voltage Sensitive Relays have been specifically designed for a wide variety of 12V applications. The VSR units sense the input voltage generated and automatically connect/disconnect the appliance or circuit at pre-set voltages, eliminating the possibility of discharging the primary starting battery.